:Job Summary:Conventional/ Manual Lathe Machine Operator responsible for the manufacturing of Power Section (Stator & Rotor) by following procedures and SOPRESPONSIBILITIES:

• Manufacturing Stators and Rotors for usage in oilfield directional drilling
• Follow procedures related to stator and rotor manufacturing process
• Review of the necessary manufacturing procedures frequency to be fluent and aware of the critical parameters related to the process
• Verify quality control checks at each manufacturing process, prior to planning or transferring the job to the next process of manufacturing
• Support and participate in the Organizations Continual Improvement program and any problem-solving initiatives
• Follow the operating procedures (SOP) and perform the task based on the Job Hazard analysis performed
• Operation of overhead cranes in the movement of parts or products
• Select the required tools as per component and programming
• Record the inspection results in respective format
• Knowledge of tool holders, cutting tools, boring bars, fixtures, inserts and other accessories used on various machines
• Report any abnormalities or variations observed in the manufacturing process to the concerned parties
• Ensure the tools, gauges and equipment's used in manufacturing are maintained properly
• Verify the calibration date of inspection tools, prior to inspection
• Document and maintain checklist, paper routers, or any ERP system that are in place
• Assist and support in the repair work of any machine or areas in the facility
• Handling of products, tubes & core at elevated temperatures by following the necessary safety procedures
• Follow the house keeping as per the 5S requirements
• Suggest or raise observation on any improvements, risk, safety concerns and good practices
• Ensure to comply with all NOV HSE procedures and policies and maintain relevant HSE logs
• Observe HSE regulations, encourages safe working practices, corrects obvious hazards immediately or reports them to the proper personnel

BEHAVIORAL SKILLS/COMPETENCIES & EXPERIENCE REQUIRED:

• Perform daily operator checklist of machines
• Capture/measure necessary process parameters and record the readings
• Ensure controlled use of elastomer & chemicals issued to shop floor
• Check the stator or rotor prior to starting any process and report if in doubt
• Ensure the stator/rotor is processed to the next step only after complete review of task performed
• Ensure machines are running as per the requirement
• Assist maintenance technicians when critical machine breakdowns are been attended
• Provide training to any new hire / operators that are under the certification program
• Contribute to cost reduction efforts by actively seeking and reporting opportunities for reduced costs
• Other duties, as assigned by the supervisor

Qualifications: (Education/No. of Years of Experience)

• High School Diploma or equivalent with knowledge in basic math

Skills, Training, special knowledge, and/or Language skills

• Knowledge of the proper use of measuring tools/gauge and tools
• Understand routers, drawings and procedures
• Experience operating Machines such as conventional/ Manual Lathes machines in a heavy manufacturing environment
• Able to communicate in English (both writing and orally)
• Experience in safe use of power tools used in Manufacturing Industries

NOV